JoshuaSlowpoke777@lemmy.world to No Stupid Questions@lemmy.ca · 11 months agoIs PLA a good material for 3D printing a tool intended to remove pack ice from a driveway?message-squaremessage-square8fedilinkarrow-up19arrow-down12
arrow-up17arrow-down1message-squareIs PLA a good material for 3D printing a tool intended to remove pack ice from a driveway?JoshuaSlowpoke777@lemmy.world to No Stupid Questions@lemmy.ca · 11 months agomessage-square8fedilink
minus-squareJoBolinkfedilinkarrow-up2·11 months agoHow big is the printer? This sounds like a very expensive, bad idea.
minus-squareJoshuaSlowpoke777@lemmy.worldOPlinkfedilinkarrow-up1·11 months agoI was thinking something like a chisel, but yeah, these comments suggest even that would break before the ice.
How big is the printer? This sounds like a very expensive, bad idea.
I was thinking something like a chisel, but yeah, these comments suggest even that would break before the ice.
Try salt?