Having a Creality Ender 3 Pro. Have upgraded the mainboard to a new Silent mainboard. Installed this Extroduer and also have a glass bed. I also purchased another glass bed to exchange the scratched one.
What should I do about my problem? Is my only solution to buy a CR-Touch Sensor? How does the sensor even work? Will it also scratch it when I am not careful enough or is it user friendly and fully automated?
I don’t have any other bed except the glas one for now. Should I rather purchase a flexible sheet for the bed instead of a glas bed?
The steps are the same regardless of what you’re using for a Z sensor. The only issue I see is if your limit sensor physically won’t allow the gantry to move lower due to its mounting position otherwise it’s a ‘soft limit’ set exclusively in the firmware (which the above steps allow you to reconfigure).