I have an Ender 3 S1 that I use every couple of months at this point because it’s just such a pain to use. I have to adjust the bed tramming and z offset and run auto bed leveling for every single print and often times that’s still not good enough.
It will often take 30+ minutes just to get the first layer going down successfully.
Is this a me problem or did I lose the creality lottery?
I probably count as that type of person you describe. I found a model on Lemmy that I really wanted to make and ended up buying an Ender 3 v2 cheap with a coupon at Micro Center. Has it totally been trouble-free? No. But I got it for a hundred bucks, plus a few addons (auto-level, flexible magnetic bed). I’d have to pay significantly more for a nicer one, when this is just an experimental hobby. I don’t care if I have to fiddle around a little more to get my occasional print going. In a way fine-tuning is part of the problem solving and tinkering I’m really looking for. I don’t care if the quality is less than what another printer can do. I don’t need a Cadillac when a Geo gets me to the grocery store just fine.
Oh, and most of my issues were caused by shitty filament. Once I went from some weird stuff on Amazon to the Inland I’ve had better success with, things went way better. I’m surprised that’s not mentioned more actually.