I’m talking YouTube channels with a few thousand views, streamers with single digit viewers, writers who only get a few reads on their submissions.

Since the fediverse is all about boosting connection to smaller voices, let’s share the love!

  • CanadaPlus@lemmy.sdf.org
    link
    fedilink
    English
    arrow-up
    18
    ·
    1 year ago

    Sam Zeloof

    You know how modern semiconductor components are made in billion-dollar fabs? Well, you can actually make them in a garage, at least simple ones.

    • bricklove@midwest.social
      link
      fedilink
      English
      arrow-up
      4
      ·
      1 year ago

      Damn, he’s got a lot of equipment though. I was hoping I could just setup a jig with 2x4s and melt sand with a blowtorch

      • CanadaPlus@lemmy.sdf.org
        link
        fedilink
        English
        arrow-up
        2
        ·
        edit-2
        1 year ago

        Most of it isn’t strictly necessary. Like, he has sputtering equipment for making layers that can’t be chemically deposited for example. The one where he makes a MOSFET on camera involves just spin coating with tape and some random motor, a little tube furnace to bake impurities in and chemical etching IIRC.

        He uses commercially available blank wafers; you’d need a small arc furnace (or at least a blast furnace and patience when your product is mostly iron) to make silicon from sand and something resembling a meth lab to clean it (and then you’d grow and cut your wafer, but that could be done on a desk I’m sure).

    • justdoit@lemm.eeOP
      link
      fedilink
      English
      arrow-up
      2
      ·
      1 year ago

      Wait this is incredible.

      I don’t even know how to hold a hammer correctly let alone solder a chip, but I might have to try a new hobby.

      • CanadaPlus@lemmy.sdf.org
        link
        fedilink
        English
        arrow-up
        2
        ·
        1 year ago

        It didn’t look that hard in the transistor video, actually. His layers were in no way straight or pretty, all that matters is the topology and timing on the baking steps.